1 cylinderの例文

• On most automotive engines, the timing is set based on the # 1 cylinder.
• The number 1 cylinder position on the cap should be noted before a cap is replaced.
• Most distributor caps have the position of the number 1 cylinder's terminal molded into the plastic.
• Upon inspection there was a hole in the front bottom of the engine near the # 1 cylinder.
• The Generation 1 cylinders came in two lengths, only had one input and worked on pressure or vacuum.
• After the Second World War Triumph made successful models including the 200 cc Cornet split single two-stroke and the split-single 1 cylinder 350 cc Boss.
• The 1 cylinder, 197 cc, two-stroke motor produced 9 horsepower ( 7 kW ), had a crank starter, and drove only the right front wheel.
• Marine Diesel, 10 HP, 1 cylinder, 4 stroke, water cooled, max speed 2500 rpm, ratio 1.87 : 1 with 12 volt dyna starter.
• However, in the 3.5L there exists a different situation that appeared on some engines; eventual head gasket erosion, and thus passage of oil into the # 1 cylinder.
• An exception is the Ford Flathead V8 where the number 1 cylinder is on the right front of the engine ( same as other Ford V8's ) but this cylinder is not the front cylinder of the engine.
• Because of this, many drives still have a surplus of sectors ( less than 1 cylinder in size ) at the end of the drive, since the total number of sectors rarely, if ever, ends on a cylinder boundary.
• This engine has the cylinders numbered 1-3-5 on the left-hand bank ( front bank for FWD applications ) and 2-4-6 on the right-hand bank, the number 1 cylinder being the furthest from the flywheel end.
• Using these, it was possible to make the Generation 1 cylinders pull down as well as push up, however the pulling wasn't as strong as the pushing, and this prompted Lego to redesign the pneumatics into an easier-to-use and stronger system.
• To do this Vega engineers had to design a special engine oil baffle to prevent oil from entering the No . 1 cylinder, batteries had filler caps located high up on the rear edge of the case to prevent acid spilling, the carburetor float bowl had a special tube that drained gasoline into the vapor canister during shipment, and the windshield washer bottle stood at a 45 degree angle.
• There will be other issues with the limits to plain mechanical strength, since the con rods of the big engine will only have 10 ^ ( 2 / 3 ) as large a cross sectional area, and thus only 10 ^ ( 2 / 3 ) as much strength, while the piston will be 10 times as massive, unless you make it shallower from top to bottom, so the conrods will break at a lower rpm on the 1 cylinder engine; again, similar to the reason why elephants have thicker legs than deer . talk ) 05 : 22, 12 September 2011 ( UTC)