liquid sealの例文

• Meters that rely on a liquid seal create a relatively low pressure drop.
• A liquid seal is usually used for smaller vehicles, while the mechanical seal is used for larger vehicles.
• The Cervo also received some minor updates across the line, with new liquid seal engine mounts and suspension changes.
• To maintain pressure on a separator, a liquid seal must be effected in the lower portion of the vessel.
• A third problem is where the lower end of the liquid seal is simply a U-trap bend in an outflow pipe.
• This liquid seal prevents loss of gas with the oil and requires the use of a liquid-level controller and a valve.
• A liquid seal is created by the design of the filler pipe, which creates a seal with the liquid flowing into the tank.
• Magnetic liquid seals are engineered for a wide range of applications and exposure but are generally limited to sealing gases and vapors, not direct pressurized liquid.
• Second, the liquid seal also provided defense against air being drawn into the hydraulic main : if the main had no liquid within, and a retort was left open with the pipe not shut off, and air were to combine with the gas, the main could explode, along with nearby benches.
• The air in pockets is absorbed by the liquid, which pulls liquid up into the piping until the air pocket disappears, and can cause activation of water flow outside the normal range of operating when the storage tank is not full, leading to loss of the liquid seal in lower parts of the mechanism.
• U . S . Patent 0, 567, 818-Electrical Condenser-1896 September 15-Condenser constructed or provided with means for exclusion of air or gas; Armature composed of a conducting liquid; Armatures in two separate bodies of conducting liquid insulated electrically and contained in a receptacle; Insulating liquid seal on the surface of the conductive liquids.
• There were two purposes to the liquid seal : first, to draw off some of the tar and liquor, as the gas from the retort was laden with tar, and the hydraulic main could rid the gas of it, to a certain degree; further tar removal would take place in the condenser, washer / scrubber, and the tar extractor.